Ambar Bond APS (FGM) Bonding Adhesive

Description

Benefits

• Increased polymerization standard and decreased sensitivity to moisture:
  Benefits of the APS technology. Ideal for areas with difficult control of the moisture level, such as in restorations on lower teeth or very close to the gums.
• Higher adhesive potential:
  The presence of MDP in the composition makes a chemical bond with the dental structure, which adds mechanical adhesion, which gives to the product a superior and long-term adhesive strength.
• High conversion degree:
  Provides greater stability of the adhesive interface.
• Higher stability and resistance for the adhesive film:
  Due to the presence of treated silica nanoparticles.
• BPA-free:
  Ensures safety and health.
• Colourless aspect:
  Does not interfere on the aesthetics of restorations and cementations.

Recommendations

• All classes of direct restorations with composites (classes I, II, III, IV and V) and light-curing glass-ionomer cements.
• Adhesive cementation (together with resin cement) of prosthetic pieces (posts/cores, crowns, onlays/inlays and veneers) made of fiberglass, ceromer, ceramic, composite and metal.
• Ceramic and composite adhesive repairs;
• Use as a primer for metals or ceramics

Step By Step

• The surface to be restored must be cleaned and then etched with phosphoric acid at 37% Condac 37 (FGM) for 15 seconds (same time for enamel and dentin). It is important to isolate the tooth, whether with complete or relative isolation (depending on the case).
• Rinse the surface with abundant water and dry the cavity until it is moist, not dehydrated.
• With a micro-applicator Cavity brush (FGM), apply the adhesive rubbing the first drop of the product for 10 seconds. Next, apply a new layer of adhesive to the same surface for other 10 seconds.
• Apply an air jet for 10 seconds, which helps to evaporate the solvent and, consequently to increase adhesion.
• The adhesive must be light-cured for 10 seconds, then perform restoration. Note: for intra canal adhesive application, the photo activation time must be extended to 20 seconds.