MTA+ Applicator (Tool for prepared measure of MTA+ material)

Description

Properties of MTA+ Applicator

The tool is made of  corrosive – resistant stainless steel.

Handling the product

In order to use the product, insert the piston into the corresponding handle, then  pull back the piston about 1 cm.

Put the previously prepared MTA+ material  on the glass plate and thrust the  measurement of the preparation into the carrier tip.

Place the tip of the applicator directly into the area intended, and then press the plunger to  apply the material.

WARNING! After use, any residue of material should be removed from the device and it should then be rinsed with water to ensure it is completely clear of any cement to prevent hardened, encased cement developing.